Evil Bikes Following MB

"

ROCKSHOX SUPER DELUXE RCT DEBONAIR:

Prior to performing shock adjustments, determine riding weight ( fully geared up ). Push the shock O-ring against the wiper seal and push the sag adjuster on the non drive side of the Delta Link forward. Lean up against a sturdy wall, friend, or telephone pole and sit on the bike. Being careful not to tip over, dismount the bike and check the SAG indicator. The SAG indicator should barely cover the 30% mark and the O-ring should measure between 10-13mm from the shock body for ideal setup. The Following MB uses a high volume air canister which compliments the progressive spring curve of the Delta System Suspension, if a less progressive feel is desired then experiment with different air volume spacers. We also found that the Following MB performs great in the "Descend" position for most riding conditions, however, for sufferfest climbs and high speed trail riding the "Pedal" position also works well.

NOTE:

These are just guidelines to start you on your suspension tuning journey. Its very important to tune your front and rear suspension together to get the best set up possible. When purchasing a full bike build from Progression Cycle your initial suspension settings will be tuned for you before we send you on your way.

NOTE:

The dual progressive leverage rate curve might make some spring rates seem stiff, we encourage you to try different rates that will allow you to sit deeper into the suspension travel and find that perfect set up.

HOW DO I ADJUST MY FLIP CHIPS?

Remove upper and lower linkage bolts then remove 3 flip chip bolts. Lightly wiggle flip chips free and flip 180 degrees with desired position facing up. The flip chip position will be visible when sitting on the bike and should read Low/XLow depending on model.

WHAT SIZE IS THE SEAT POST?

The Following MB uses a 30.9 Stealth seat post and a 34.9 seat clamp.

WHAT IS THE WARRANTY ON THE FOLLOWING?

3 Year limited warranty

WHAT TYPE OF HEADSET DOES THE FOLLOWING USE?

The Following MB uses an FSA Integrated Tapered No.58/68 headset, alternatively bearings from other suppliers can be used. Upper Bearing 30.2x41x6.5 36°/45° Lower Bearing 40×51.8×8 36°/45°

WHAT IS THE SUGGESTED FORK LENGTH FOR THE FOLLOWING?

The Following MB was designed around 120mm and 130mm forks, but works well with a 140mm fork. This slackens the head angle to 66.4° X-Low and 67.0° Low and makes for some ripping descents and cornering.

WHAT SHOCKS CAN THE FOLLOWING MB ACCEPT?

The Following MB works with the Rockshox Super Deluxe RCT Debonair, 165x45 with custom Evil tune, but will also fit most trunnion mount metric 165x45 non-external reservoir and external reservoir shocks. Contact us at info@progressioncycle.com for proper tune and fit information.